Versions Compared

Version Old Version 28 New Version Current
Changes made by

Patrick Joericke

Patrick Joericke

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Panel
titleUser Manual

new  ISE-NIN MANUAL ise-nin_manual_1.1.04_eng.pdf   from 1410.JunMay.2023 2024 released by Black Corp.ISE-NIN Manual 1.0.0-updated on 23Dec2022.pdf old version


please use the BC website for latest infos:

https://black-corporation.com/shop/product/ise-nin/#support


Panel
titleFirmware Download

new latest Firmware   OS 1.1.0 released June2023ISE-NIN 4  released 10 May 2024

isenin_cm4_1.1.0 Release4.zip   > including Install.guide from Black Corp.


This version is for prebuilt units  and DIY Versions (DIY Version need the initial install as described at bottom of this page, before you can update to latest version)


Expand
titleold versions

Firmware 1.1.0 released June2023

ISE-NIN 1.1.0 Release.zip   > including Install.guide from Black Corp.


30.Nov.2022 deprecated

Release Date:   30.Nov.2022

Release info: First RC 1.0.0 released incl. more Banks/Presets 

Device compatibly: DIY Version and prebuilt Version

RC1.0.0 ISE-NIN-30112022.zip

Benedek_bank.syx (for DIY Versions must be installed manually) 


04.Nov.2022:  deprecated

new beta including vintage presets

you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.

ISENIN_1.0.2B.zip

if you still have the old beta, you have to install again both files with ST-link  and you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.


08.Oct.2022 depracted

1.0b beta :  that’s an beta version, install both files on the devices, start with 1.0b1 and install 1.0b2

In this beta are no presets available !

ISENIN_1.0B_2.hex

ISENIN_1.0B_1.hex


September 2022 depracted

0.4/0.7 in current test for beta not released for customers (tested by Patrick)



...

Instructions for Flashing




1.1 Connect STM LINK to the Motherboard with the ribbon cable from the programmer and connect the STlink programmer with your Mac or PC

1.2 Turn ISENIN on

1.3 Open STM Cube Programmer  or ST LINK utility (cube programmer is the latest software, but STlink utility is fine too and often better)

1.4 Select ST-Link, select connect (which reads the ISE-NIN uC memory)

1.5 Select erasing and programming button (in STlink utility its "program & verify)

1.6 Browse select ISENIN 1.0.0_1.hex file from your pc/Mac. -   Start programming *** (update Jun.2023 - use the latest hex file from the download at top of this page)


1.7Repeat 7 Repeat the procedure described above and select ISENIN 1.0.0_2hex    Start programming as before (program and verify) (update Jun.2023 - use the latest hex file from the download at top of this page)

***you don't need to restart the ISE-NIN after first programming step, in case the ST-LINK tool hangs, just reconnect the USB cable.

1.8 Disconnect and restart ISE-NIN – its important to remove the Programmer from the ribbon cable - or the device will not start !! 

...