ISE-NIN Manuals and Firmware

On this Page are 3 Firmware installation guides described:

1. for DIY builds which are on beta firmware (deprecated due to RC release)
2. for DIY builds which are empty ( First time Installation for DIY Builds)
3. Firmware Updates for Prebuilt Versions (not available yet - because we are still on RC 1.0.0)

1 . DIY builds which are on beta firmware : (depracated)

2. First time - Firmware Installation for DIY Builds

Instructions for Flashing

2.1 Connect STM LINK to the Motherboard with the ribbon cable from the programmer and connect the STlink programmer with your Mac or PC

2.2 Turn ISENIN on

2.3 Open STM Cube Programmer  or ST LINK utility (cube programmer is the latest software, but STlink utility is fine too and often better)

2.4 Select ST-Link, select connect (which reads the ISE-NIN uC memory)

2.5 Select erasing and programming button (in STlink utility its "program & verify)

2.6 Browse select ISENIN 1.0.0_1.hex file from your pc/Mac. -   Start programming ***

2.7Repeat the procedure described above and select ISENIN 1.0.0_2hex    Start programming as before (program and verify)

***you don't need to restart the ISE-NIN after first programming step, in case the ST-LINK tool hangs, just reconnect the USB cable.

2.8 Disconnect and restart ISE-NIN – its important to remove the Programmer from the ribbon cable - or the device will not start !! 

2.9  Start ISE-NIN and go in the ISE-NIN Menu and perform "reset all settings", otherwise some functions doesn't work.

(do not miss to run the calibration procedure which is described in the ISE-NIN Build guide

2.10 Now install /send by USB-MIDI with a sysex tool (sysex librian or other) the above Benedek.sysex file otherwise is the Benedek bank still empty. read step 2.11 !!!!

2.11 perform again a reset all settings and reboot the ISE-NIN after you sent the sysex file, or it can happen that bank is still empty.

there no receiving info on the synth when you send the sysex file to the synth.

3. Firmware update for rebuild versions:

not available yet- no new FW. released yet (current Version is RC.1.0.0) valid until this page is updated

Changelog: (of this page)