ISE-NIN Manuals and Firmware

The Firmware is still beta but official released, please check this page weekly for a stable release candidate to avoid trouble with functions and calibration.

User Manual:

tbd. by BC

Firmware:

04.Nov.2022:  

new beta including vintage presets

you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.

ISENIN_1.0.2B.zip

if you still have the old beta, you have to install again both files with ST-link  and you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.

Firmware Installation

The latest Firmware is on a separate page : ISE-NIN Manuals and Firmware

Instructions for Flashing

• Connect STM LINK to the Motherboard with the ribbon cable from the programmer and connect the STlink programmer with your Mac or PC

• Turn ISENIN on

• Open STM Cube Programmer  or ST LINK utility (cube programmer is the latest software, but STlink utility is fine too and often better)

• Select ST-Link, select connect (which reads the ISE-NIN uC memory)

• Select erasing and programming button (in STlink utility its "program & verify)

• Browse select ISENIN 1.0b-1.hex file from your pc/Mac. -   Start programming ***
• Repeat the procedure described above and select ISENIN 1.0b-2.hex     Start programming as before (program and verify)

***you don't need to restart the ISE-NIN after first programming step, in case the ST-LINK tool hangs, just reconnect the USB cable.

• Disconnect and restart ISE-NIN – its important to remove the Programmer from the ribbon cable - or the device will not start !! 

1.x → wait

Changelog: (of this page)