Known Issues and Building tipps for yocto 808 Clone Batch2 - January 2014 pcb version
...
(the building instruction was updated to correct value on 10.2/11.2.2014)
R44 from 100k to 50k otherwise a 100k Trimmer to change the„tuning range“ for TM1 
validation July2014
Chassis
unscrew the nuts from all pots/encoder or the board bends.
...
This was a little tricky to figure out:
clap reverb mod -
replace r376 (47k) with 100k pot trimpot
This will vary the reverb between full and completely off.
...
Cowbell
Range: replace R44 und R45 with (xxx kOhm) and (xxkOhm).to a 50k trimmer
adjiust the trimmer on left hand - after a bleedthru you must trim one trimmer a bit more to get a cowbell.
you can doublecheck them by using a scope
http://www.e-licktronic.com/forum/viewtopic.php?f=16&t=189&start=20
Low Noise Ratio (SNR) for Mastersection
...
change in the Mastersection all carbonfilm resistors to Metallfilm resistors and change all cheap electrolyt caps to LOW ESR caps..
change the ceramic cap (220p) to a c0g capaciator
Low Noise Ratio (SNR) for Mastersection
...