Content Comparison

As you can see you also need to do a jumper wire between the solder point marked A on the pixie cpu and pin 10 (!WE pin) of *any* of IC 7,8,9 or 10 (they’re all connected to the same signal)
Please note:
* This is on the back of the 808
* you solder the pins on the cpu on the “wrong“ side
* the jumper wire can be soldered directly as it’s just one wire, I use a pin header and patch cable here mainly during development as I can easily remove the cpu without having to desolder anything
* as the cpu is upside down, make sure you connect the midi wires the correct way!
* as always - pin 1 and 42 is unused and can be left unconnected (pin 1 is the hole with a square pad)

Image ModifiedImage ModifiedImage ModifiedImage Modified