...
Steps to your completed device:
important Info: the logicboard is mounted with the components thru the ucb and lcb boards - like this:
please read the guide before you start the build to understand my preferred guide, its possible to assemble the module in other ways too !
...
- start with the assembly of the Logicboard, don't attach both long headers !
- begin with the resistors you can solder from component side and turn the pcb - solder from solderside too.
- place and solder the rectifiers and ferrite beads
- place and solder the IC sockets (dont fit the ICs)
- place and solder the capacitors
- place the Power header (4pin MTA156) from solderside as shown here:
ucb & lcb PCB
- prepare the long headers: the distance between the controlbaord and logicboard must be 14-15mm, the big WIMA 4.7uF caps
the pinheaders are 7-8mm high, connect 2 together.
mount the male and female header together - the boards have a silkscreen layout for the 6,3mm jack - this is the component side !
- mount on the frontpanel with 4 jacks in each corner on one pcb, solder one pin on each jack, thats needed to have enough space to solder the pin headers like this:
...
14. if 13. is ok - add all ICS and test the module
testing process :Active Splitter
Connect a Audiosignal to the Active Splitter IN 1AA
this signal can be found now on left Out row and second Out row.
connect a audiosignal to the active splitter IN B
this signal can be found now second Out row.
testing process buffered multiple:
Connect a CV signal to the Buffered multiple IN A
this signal can be found now on left Out row and second Out row.
connect a CV signal to the Buffered multiple IN B
this signal can be found now second Out row.