ISE-NIN DIY PSU card upgrade
DSL-man.de offer exclusive a brand new technical updated PSUcard with the best Specs as described here:
https://github.com/dslmande/ISE-NIN-PSU-MK2-public
Why bother
The stock board — silkscreened DIY POWER BOARD MK1.0 — derives eight rails from one 12 V input. Three of them matter more than the rest:
±15 V comes straight off an isolated DC/DC module. The module is specified at 100 mV pp of ripple and noiseat roughly 330 kHz, and behind it sit only 100 µF and 0.1 µF. That ripple lands on eight analogue voice cards unfiltered.
+2.5 V is not a housekeeping rail. It is the
VREFinput of the sixteen SSI2131 oscillator chips, and through the expo-scale current it sets the sensitivity of the exponential converter and the level of every waveform output. The factory board makes it with a TL431 shunt reference, whose drift is in the same league as the 200 ppm/°C scale-factor drift of the oscillator chip itself.The 1 A fuse carries 1.21 A — 121 % of its rating, continuously.
There is also no reverse-polarity protection. The 1N5817 on the board is the freewheeling diode of the 3.3 V buck, not an input protection.
The PCB comes as described before with SMT preassembled parts, you have to solder few THT parts (Electrolyte caps, fuse holder, 2 resistors, LEDs, MTA jack - which are not included)
The PCB is available for 150€ each (10 users required)
170€ each for a batch with 5 people (minimum order for PCBA)
Shipping fees within Germany is 7€, EU Countries 15€, USA and others 28€.
plus you need:
Mouser project BOM https://www.mouser.de/api/CrossDomain/GetContext?syncDomains=www&returnUrl=https%3a%2f%2fwww.mouser.com%2fde%2fTools%2fProject%2fShare%3fAccessID%3d3eb82a4963&async=False&setPrefSub=False&clearPrefSub=False (dont order yet ! ) I have to make a check against the PCBA when I order the PCBs.
for the required hand soldered parts, (Fuse-holder, Electrolyte caps, LEDs, 2 resistors, MTA jack, 3x DC-DC Converters)
you can re-use your old Traco Dc-Dc converter (but you just be warned, the desoldering is complicated)
do not use a other brand, it must be the Traco THN 30-2423WI or THN 30-2423WIR
just send me a Email: patrick@DSL-man.de